Monday, July 10, 2017

How to Add a curb subassembly

Add a curb subassembly
  1. In the Tool Palettes window, on the Curbs tab, click UrbanCurbGutterGeneral.
  2. In the drawing, click the marker point at the top-right edge of the travel lane.
    Note:
    If you attach the subassembly to the wrong marker, you can move it to the correct location. Press Esc to exit subassembly placement mode. Select the subassembly you wish to move. A blue grip is displayed when the subassembly is selected. Select the grip, and then click the correct marker point.
Add a sidewalk subassembly
  1. In the Tool Palettes window, on the Basic tab, click Basic Sidewalk.
  2. In the Properties palette, under ADVANCED, specify the following parameters:
    • SideRight
    • Width1.5
    • Buffer Width 10.5
    • Buffer Width 20.5
  3. In the drawing, click the marker point at the top, back of the curb.


Add a daylight subassembly
  1. In the Tool Palettes window, on the Basic tab, click BasicSideSlopeCutDitch.
  2. In the Properties palette, under ADVANCED, specify the following parameters:
    • SideRight
    • Cut Slope2.000:1
    • Fill Slope4.000:1
  3. In the drawing, click the marker point at the outside edge of the sidewalk subassembly.
  4. Press Esc.
    This action ends the subassembly placement command.
Mirror the subassemblies to the left of the baseline
  1. In the drawing, select the four subassemblies you added.
  2. Right click. Click Mirror.
  3. Click the marker point on the assembly baseline.
    The subassemblies are displayed on the left side of the assembly marker. The Mirrorcommand creates a mirror image of the selected subassemblies. All the subassembly parameters, except for the Side parameter, are retained.
    Note:

3 Comments:

At August 7, 2017 at 5:00 AM , Blogger devjiblog said...

very nice comment

 
At August 9, 2017 at 2:39 AM , Blogger EKA CG said...

wow how do that

 
At August 10, 2017 at 11:29 AM , Blogger Unknown said...

very interesting article thank you for sharing

 

Post a Comment

Subscribe to Post Comments [Atom]

<< Home