Creating an Assembly
Create an assembly baseline
- Open Assembly-1a.dwg, which is located in the tutorials drawings folder.
- Click Find. tab panel drop-down
- In the Create Assembly dialog box, for name, enter Primary Road Full Section. Click OK.
- When the ‘Specify assembly baseline location’ prompt is displayed on the command line, click in the rectangle under the profile views.The viewport zooms to the assembly baseline, which looks like this:
Add a lane subassembly
- If the Tool Palette containing the subassemblies is not visible, click Home tab Palettes panel Tool Palettes Find.
- In the tool palette, right-click the Tool Palettes control bar. Click Civil Metric Subassemblies.
- Click the Lanes tab.
- Click LaneSuperelevationAOR.
- In the Properties palette, under ADVANCED, specify the following parameters:
- Side: Right
- Width: 3.5
- Potential Pivot: No
- In the drawing, click the marker point on the assembly baseline.The right lane subassembly is now attached to the assembly baseline.
0 Comments:
Post a Comment
Subscribe to Post Comments [Atom]
<< Home